![]() Functions are attached at the end of the post. The third is the "capacitor_selection" block, which determines which capacitors will be enabled at any given moment. The "calculate_capacitor_var" block that collects the values of capacitor_var and instantaneous capacitors. There are 3 Matlab Function blocks in the model, the first one is the "calculate_capacitor" function: it gives the output of the required capacitor amount as "capacitor_var", with the inputs of the system's active power, instantaneous power factor value and target power factor value. Since the reactive power is variable, it is necessary to write an algorithm that decides which capacitor will be activated at which moment. The purpose of the system is to meet the reactive power generated by the loads with capacitors and to keep the power factor above 0.95. ![]() In this design, there is a 3-phase source, 4 three phase loads (defined as their active power is constant, their reactive power is changed randomly every 3 seconds), 6 three phase breakers and 6 capacitors connected to them. I am designing a power factor correction system from Matlab Simulink.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |